Game Settings

FragFX Shark PS4/PS3

Fine tune your FragFX Shark by adjusting the Dead Zone wheel on the FragChuck, the mouse sensor DPI and the in-game settings (e.g. aim/look sensitivity).  

Dead Zone: The adjustment wheel (controller dial) function on the FragChuck is used to tune the ‘dead zone’ from 1 to 9. The ’dead zone’ is an area around the centre of the analog stick (in the Shark’s case the mouse movement) which allows for the aim to rest without the on screen reticule moving all over the place. You can adjust this in a way to get pixel point accuracy. Start from 1 upwards.

DPI: The mouse sensor is pre-set to 1500 DPI (factory setting). The range values from 250 DPI to 2000 DPI. You can change the DPI in increments of 250 DPI. The higher the DPI, the more detailed the mouse reads, the more precise you need to move it. Change DPI: Press & hold FRAG BUTTON (F) and click the mouse wheel right to increase by 250 DPI. Press & hold ‘F’ and click mouse wheel left to decrease by 250 DPI. Repeat this until you find your best DPI setting. Higher is not always better! 

In-game settings: in the ‘options’ menu of the game select the look/aim sensitivity that fits your game play and above controller settings best. Different games provide various levels of settings. Start at moderate levels.  Working with these parameters allows you tune your FragFX Shark to your preferred game play style.

Also, we recommend that you disable the 'aim-assist' (in-game / options), as you will be faster and more precise with the FragFX.

Game settings will vary from game to game so you may want to make a note of your favourite settings. Once you are used to this, it's a matter of seconds to be ready to rumble.

Here is a list of recommended game settings.